Snap N Go P1 OBD Power Cable for BlackVue Dashcam w/ Parking or ACC Mode Switch

Snap N Go P1 OBD Power Cable for BlackVue Dashcam w/ Parking or ACC Mode Switch

• - Snap on OBD Port and You Are Ready To Go. In Less Than 5 Minutes You Are Be Able To Protect Your Car In Parking Mode
• - Battery Discharge Prevention. At Parking Mode, the Snap-N-Go will stop using battery power at 12V automatically to prevent battery grain.
• - Control Button To Switch From Normal ACC Mode and Parking Mode. You can easily switch from two modes depend on your demand.
• - Maximum Dashcam Protection Through Micro Controller Chip.The current from OBDII provide stable power for your dashcam than directly from battery. Customized software and current control enable SNG to provide smooth and stable power for your BlackVue dashcam. It will stop powering the BlackVue after 5 minutes when engine off at ACC mode
• - 10F Length Cable Fit Most Of Sedans, SUV and Pickups. 

Power Magic Pro installation requires basic electric knowledge and Ninja skills to crawl down to find the right fuse. And the control box is also not so easy to hide under the dash. That's why we designed Snap N Go for you. Just need to locate the OBD connector, plug SNG, and you are ready to go. 

• - Compatible with DR900S DR750S, DR650S, DR490, DR470, DR450 and DR430 BlackVue Models
• - Not Compatible with DR490L or DR750LW or other brands.
• - Easily Power your dashcam with two different modes: Parking, AAC
• - Parking Mode lets the camera record while the car is off and monitors your car battery to shut off the camera if the battery of the car gets low
• - AAC modes allow the camera to turn off when the car is off and starts up as soon as you start your engine

How to:

-Simply plug the adapter into your OBD II Port

-Run the wire under the rubber of your lining

-Plug it into your Dash Cam for Instant Power